Your garage door can take a lot of wear and tear over years of use. The problem with that is, you cannot be sure when the door will give up in the event of violent weather. If the bottom of the door were in serious need of repair, you would do well to replace the damaged sections with new panels. If you are not able to do this yourself, check out the best garage door repair service in the neighborhood and ask them for help.Equipment
• Ladder
• Hammer
• Vise clamps
• Nut driver (ratcheting type)
• Power drill and bits
• Knee pads
• Scrap 2-by-4-inch boards
• Four-panel garage-door section
Directions
• Lift up the garage door and unplug the power to the automatic opener system. After that, remove the center arm, if there is one on the door.
• Take out turnbuckles fixing the tension springs in place, and if there are lots of them, make sure to be careful while undoing them.
• Lower the door carefully, and then with the 2-by-4 to, prop it a few inches off the ground so that it is easier to take out the bottom panel.
• Fix two vise clamps to the door tracks, right below the second panel’s bearings. This is to hold the upper part of the door in place while you are removing the prop and placing it at the lower panel’s center bracket.
• Get the ratcheting nut driver and use it to undo the bolts on the bottom panel brackets. The center bracket bolts should go last.
• Put another 2-by-4 on its edge, under the door to brace the bottom panel when you bring that down. Take out the 2-by-4 carefully by propping the garage door at the center. The vise clamps should work to hold the upper panels of the door steady.
• Take out the bolts holing the bottom panel up at the center bracket, and then take aside the panel and replace with a new one. The bottom corners in the cable anchors need to be lined up just right, and the hinges and brackets will need to be used as setting for spots to drill holes.
• After attaching all the brackets, the holes will need to be pre-drilled, a new handle mounted. After that, raise the door and connect the springs and the automatic opener. Then, prime and paint the door.
Is it OK to Replace Just Damaged Section of the Door?
You may have damage on just one of the panels, and whether this is the bottom one or middle one, it is enough to replace just the damaged sections, as opposed to the whole door. However, if you were changing more than one section, the cost involved would be close to what a new door is worth, which means a total replacement is usually a better option. Again, it is good to get in touch with the best garage door installation Huntington Beach services, and let them do the job for you.
More info link: http://www.garagedoorinmyarea.com/garage-door-springs-installation-huntington/